ARM Electronics CMS - Manual (Page 48)

User’s Manual
47
6.6 Sequence
This function is used to set the displaying
sequence. Before starting sequence display,
users need to add channels to the sequence
list. Right click on any channel and select
to add, or Sequence> to remove. Note that when the
channel is added to the sequence, a capital
“S” will be shown on the icon.
After the channels are added to the sequence, click on the icon and
choose to setup the sequence. Under the
option, users can setup the dwell time (1 to 120 seconds), and split mode (1*1,
2*2, 3*3, 4*4, or 5*5). lists the channels that have been
added to the list in order. Click to save the settings.
Click to empty the list. A message window will be
shown for confirmation.