Super Systems 20Q - Manual (Page 8)

4
A.1) TC INPUT A.1) TC INPUT A.1) TC INPUT A.1) TC INPUT A.1) TC INPUT
Fig. 4 THERMOCOUPLE INPUT WIRING
NOTES
NOTES NOTES NOTES NOTES:
1) Don’t run input wires together with power cables.
2) For TC wiring use proper compensating cable preferable
shielded.
3) When a shielded cable is used, it should be connected at
one point only.
3
+
_
Shield
1
3
+
_
Shield
1
4
RTD
1 3 4
RTD
1 3
A.2) RTD INPUT A.2) RTD INPUT A.2) RTD INPUT A.2) RTD INPUT A.2) RTD INPUT
Fig. 5 RTD INPUT WIRING
NOTES
NOTES NOTES NOTES NOTES:
1) Don’t run input wires together with power cables.
2) Pay attention to the line resistance; a high line resistance may
cause measurement errors.
3) When shielded cable is used, it should be grounded at one
side only to avoid ground loop currents.
4) The resistance of the 3 wires must be the same.
mkc-ssi.pmd 06/07/2004, 12.19 4