Super Systems 20Q User Manual

Page 57

CnF. 5CnF. 5CnF. 5CnF. 5CnF. 5

- Logic input 2 contact status - [C.H04]

This parameter will be available only when "d2.Fn" [C.H03] is
different from “nonE”.
Range: CLSd = The input is at logic level “1” when contact is

closed

OPEn = The input is at logic level “1” when contact is

open

- Logic input 3 function - [C.H05]

This parameter will be available only when input contact option
is fitted.
Range: nonE = Input contact not used

SP1.2 = Input contact used for SP /SP2 set point

selection (see note 2)

SP3.4 = Input contact used for SP3/SP4 set point

selection (see note 2)

SP.L.r = Input contact used for Local/Remote set point

selection (Remote when logic level is “1”)

Au.ñA = Input contact used for Auto/Manual selection

(Manual when logic level is “1”)

O.LIñ = Input contact used for output limiter activation

(Output limited when logic level is “1”)

Hold = Input contact used to stop input sampling (Hold

function) (Stop sampling when logic level is “1”)

ñ.rSt = Input contact used to reset (acknowledge) alarm

(Reset when logic level is “1”)

rE.dr = Input contact used for Reverse/Direct control

action selection (Direct when logic level is “1”)

NOTE

NOTE: See also NOTE 2) of the "d1.Fn" ("Logic input 1 function"
[C.H01]) parameter.

- Logic input 3 contact status - [C.H06]

This parameter will be available only when "d3.Fn" [C.H05] is
different from “nonE”.
Range: CLSd = The input is at logic level “1” when contact is

closed

OPEn = The input is at logic level “1” when contact is

open

mkc-ssi.pmd

06/07/2004, 12.19