Super Systems 20Q User Manual

Page 36

CnF. 1CnF. 1CnF. 1CnF. 1CnF. 1

33 = Linear

From

0 to

34 = Linear

From

1 to

35 = Linear

From

0 to

36 = Linear

From

2 to

37 = Linear

From

0 to

60 mV

38 = Linear

From

12 to

60 mV

* For these ranges it is possible to select a read-out with one

decimal figure but the instrument could not display a measure
lower than -199.9 or higher than 999.9 and the input range
will be limited by it.

NOTES

NOTES:
1) When a linear input is selected, the instrument set automati-

cally the "readout initial scale value" [C.d05] equal to 0 and
the "readout final scale value" [C.d06] equal to 4000

2) When input type has been changed, the instrument

automatically forces:

- the "ñ.In.L" [C.d05], "SS.th" [C.I09] and "brG.L" [C.I03]

parameters to the new initial scale value,

- the "ñ.In.H" [C.d06] and "brG.H" [C.I04] parameter to the new

final scale value and

- the "ñ.In.d" [C.d03] parameter to "no decimal figure".

- Decimal point position - [C.d03]

Ranges:

----.

= no decimal figure

---.-

= one decimal figure

--.--

= two decimal figures

-.---

= three decimal figures

NOTES

NOTES:
1) For main input type 1 to 6, 15 and 30 only the "no decimal

figure" and "one decimal figure" are selectable, the input
range is limited within -199.9 and 999.9 and it acts as an
input type changement.

2) For main input type 7 to 14 and 16 to 29 this parameter is not

available.

3) For linear input types (from 31 to 38) all positions are available.

- Square root extraction for main input

- [C.d04]

Ranges: dIS = square root extraction disabled

Enb = square root extraction enabled

NOTES

NOTES:
1) This parameter is available only for main input type 31 to 38.

mkc-ssi.pmd

06/07/2004, 12.19