Super Systems 20Q User Manual

Page 51

CnF. 3CnF. 3CnF. 3CnF. 3CnF. 3

- Secondary control output initial scale

v a l u e

- [C.F15]

This parameter will be available only when "S.SCL" ("Secondary
control output in engineering units" [C.F13]) is set to "YES".
Range: from -199 to 999

- Secondary control output full scale

v a l u e

- [C.F16]

This parameter will be available only when "S.SCL" ("Secondary
control output in engineering units" [C.F13]) is set to "YES".
Range: From -199 to 999

- Secondary output auxiliary conditioning

- [C.F17]

This parameter will be available only when secondary control
output is configured and “SC.Cn” ("Secondary control output
conditioning" [C.F12]) is different from “norñ”.
Range: bEFr = The functions listed at Note (**) are calculated

before

before to apply the action selected by “SC.Cn”
("Secondary control output conditioning" [C.F12])
parameter.

AFtr

= The functions listed at Note (**) are calculated

after

after to apply the action selected by “SC.Cn”
(“Secondary control output conditioning” [C.F12])
parameter.

General note on configuration group 3

General note on configuration group 3
Exiting from the configuration group 3 the instrument automati-
cally tests the "SPLt" parameter (Split range [C.F01]). When
"SPLt." parameter is enabled (= "Enb"), the instrument performs
the following actions:

If “Añ.UL” parameter ("Output value for AUTO to MAN
transfer [C.G04]) is lower than 0, it will be forced to “buñ“.

If the “SF.UL” parameter ("Output safety value" [C.G08]) is
lower than zero, it will be forced to zero.

If the “IP” parameter ("Integral pre-load" [r.d05] is lower than zero,
it will be forced to 50.0.

mkc-ssi.pmd

06/07/2004, 12.19