Super Systems 20Q - Manual (Page 59)

CnF. 5CnF. 5CnF. 5CnF. 5CnF. 5
55
- Event 2 contact status - [C.H10] - Event 2 contact status - [C.H10] - Event 2 contact status - [C.H10] - Event 2 contact status - [C.H10] - Event 2 contact status - [C.H10]
This parameter will be available only when OUT 2 is configured
as event annunciator ("O2.Fn" [C.E02] is equal to “Eun.2”).
Range: CLSd = The output is at logic level “1” when contact is
closed
OPEn = The output is at logic level “1” when contact is
open
- Event 3 function - [C.H11] - Event 3 function - [C.H11] - Event 3 function - [C.H11] - Event 3 function - [C.H11] - Event 3 function - [C.H11]
This parameter will be available only when OUT 3 is configured
as event annunciator ("O3.Fn" [C.E03] is equal to “Eun.3”).
Range: ñ.In.E=Error condition (Over-Under-Open-Shrt) on main
input (Logic level “1” when error occurs)
Cj.Er = Error condition on CJ measurement (Logic level
“1” when error occurs)
A.In.E= Error condition (Over-Under-Open) on auxiliary
input (Logic level “1” when error occurs)
ñEA.E = Error condition on any measurement (Logic level
“1” when error occurs)
Au.ñA = Auto/manual mode annunciator (Logic level “1”
when device is in manual mode)
SP.L.r = Local/Remote set point annunciator (Logic level
“1” when remote set point is used)
- Event 3 contact status - [C.H12] - Event 3 contact status - [C.H12] - Event 3 contact status - [C.H12] - Event 3 contact status - [C.H12] - Event 3 contact status - [C.H12]
This parameter will be available only when OUT 3 is configured
as event annunciator ("O3.Fn" [C.E03] is equal to “Eun.3”).
Range: CLSd = The output is at logic level “1” when contact is
closed
OPEn = The output is at logic level “1” when contact is
open
- Event 4 function - [C.H13] - Event 4 function - [C.H13] - Event 4 function - [C.H13] - Event 4 function - [C.H13] - Event 4 function - [C.H13]
This parameter will be available only when OUT 4 is configured
as event annunciator ("O4.Fn" [C.E04] is equal to “Eun.4”).
Range: ñ.In.E=Error condition (Over-Under-Open-Shrt) on main
input (Logic level “1” when error occurs)
Cj.Er = Error condition on CJ measurement (Logic level
“1” when error occurs)
A.In.E= Error condition (Over-Under-Open) on auxiliary
input (Logic level “1” when error occurs)
ñEA.E = Error condition on any measurement (Logic level
“1” when error occurs)
Au.ñA = Auto/manual mode annunciator (Logic level “1”
when device is in manual mode)
SP.L.r = Local/Remote set point annunciator (Logic level
“1” when remote set point is used)
mkc-ssi.pmd 06/07/2004, 12.19 55