Super Systems 20Q User Manual

Page 67

c) Push FUNC push-button again, the lower display will show "

b." followed by the leakage current running in the load under
test when the load is in OFF condition (see also "OUT failure
detection").

d) Push FUNC push-button again, the lower display will show "

Fd." followed by the OUT failure detection alarm status:

= no alarm

AL (flashing) = alarm
AL (steady)

= acknowledged alarm

e) Push FUNC push-button again, the lower display will show "

ñ." followed by the MAIN control output value in the range 0.0
% (-19.0 % for feedback) to 99.9 % (“ . “ shows that the
control output is > 100.0 %) or within the scale configured by
“ñC.E.L” [C.F09] and “ñC.E.H” [C.F10].
NOTE

NOTE

NOTE: When the MAIN output is a servomotor type, the
instrument shows, for this output, the feedback position
instead of the output in percent.

f) Push FUNC push-button again, the lower display will show "

S." followed by the SECONDARY control output value in the
range 0.0 % (-19.0 % for feedback) to 99.9 %
(“ . “ shows that the control output is > 100.0 %) or
within the scale configured by “SC.E.L” [C.F15] and “SC.E.H”
[C.F16].
NOTE

NOTE

NOTE: When the secondary output is a servomotor type, the
instrument shows, for this output, the feedback position
instead of the output in percent.

g) Push FUNC push-button again, the lower display will show the

value of the auxiliary input, if configured.

- Pushing FUNC push-button again, the display will come back

to the control output value indication.

All the seven types of visualization are not bound to a time out
unless OFD (output failure detection) is in not acknowledged
alarm condition.
In this situation, the instrument forces the indication described at
point d) and, if a different indication is required, it restores this
indication after time out (see “t.out” [C.I10]).

NOTES

NOTES:
1) The previous informations will be displayed only if the relative

function has been previously configured.

2) After parameter modification or monitoring, the instrument

comes back to the "normal display mode" with, on the lower
display, the indication previously selected.

mkc-ssi.pmd

06/07/2004, 12.19