Super Systems 20Q User Manual

Page 49

CnF. 3CnF. 3CnF. 3CnF. 3CnF. 3

- Main output initial scale readout -

[C.F09]

This parameter will be available only when "ñ.SCL" ("Main control
output in engineering units" [C.F07]) is set to "YES".
Range: from -199 to 999

- Main output full scale readout - [C.F10]

This parameter will be available only when "ñ.SCL" ("Main control
output in engineering units" [C.F07]) is set to "YES".
Range: from -199 to 999

- Main output auxiliary conditioning -

[C.F11]

This parameter will be available only when main control output is
configured and “ñC.Cn” ("Main control output conditioning"
[C.F06]) is different from “norñ”.
Range: bEFr = The functions listed at Note (**) are calculated

before

before to apply the action selected by “ñC.Cn”
("Main control output conditioning" [C.F06])
parameter.

- Main control output in engineering unit

- [C.F07]

This parameter will be available only when main control output is
configured.
Range: nO

= Scalable is not required

YES

= Scalable is required

NOTE

NOTE: This scaling allows you to display the output value in
engineering units instead of in percent.

- Main output decimal point position -

[C.F08]

This parameter will be available only when "ñ.SCL" ("Main control
output in engineering units" [C.F07]) is set to "yES".
Range:

----.

= No decimal figure

---.-

= One decimal figure.

--.--

= Two decimal figures.

mkc-ssi.pmd

06/07/2004, 12.19