REMKO WPM-Smart-Control-Manual for specialists-WKF-120 - Manual (Page 80)

"Messages" menu item - Expert
Pressing "OK" (right softkey) takes you to submenus of the menu item "Messages".
This is where operating messages, warning notices and fault messages are displayed.
Explanation of symbols:
Warning message
Fault message
If one of these symbols appears in the header of the control screen, please access the menu item "Mes-
sages" and display the details, with instructions on how to rectify the fault, with the key on the right.
Operating messages indicate which of the regular operating statuses the system is in.
Manual mode (relay test)
With this menu item, you can control the individual actuators (pumps, mixing valves, etc.) manually or specify
values of probes for checking.
Parameter Selection parameter
Actuators Manual mode Permanent
Deactivated
15 minutes
Solar cycle pump Output A 01.1
Auto
On
Off
Pump 1st mixed heating cycle Output A 02
Auto
On
Off
Pump 3rd mixed heating cycle -
Only WKF Duo
Output A 02.2
Auto
On
Off
Pump unmixed heating cycle Output A 03
Auto
On
Off
HW circulation pump Output A 04
Auto
On
Off
HW changeover valve Output A 10
Auto
On
Off
Changeover valve heat generator Output A 11
Auto
On
Off
REMKO Smart WP MANAGER
80