REMKO WPM-Smart-Control-Manual for specialists-WKF-120 - Manual (Page 77)

"Settings" menu item output restriction
(night mode with noise optimisation)
Fig. 90: "Output restriction" menu item
Under the level "Expert/heat pump/output restric-
tion" it is possible to adjust the following parame-
ters for the output reduction and associated noise
optimisation.
Fig. 91: Time program
Fig. 92: Time window overview
Output reduction is set to active in the factory from
22:00 hrs to 06:00 hrs. This time window can be
individually adjusted for the system operator.
The time program is active for all connected cir-
cuits (HGU, HGM 1-4,HW and cooling cycle).
Fig. 93: Output restriction HTG (normal)
If a reduction is required for "normal" heating mode
(e.g. 06:00 - 22:00 hrs) then the output can be
aligned accordingly.
Fig. 94: Output restriction HTG (reduced)
The output restriction in "reduced" operation (22:00
- 06:00 hrs) is set to 60% in the factory. Adjustment
of the output must take depending on the installa-
tion site.
Fig. 95: Output restriction cooling (normal)
If a reduction is required for "normal" cooling mode
(e.g. 06:00 - 22:00 hrs) then the output can be
aligned accordingly.
77