beautypg.com

REMKO WPM-Smart-Control-Manual for specialists-WKF-120 User Manual

Page 45

background image

Selecting the pump system

Select the pump system for the speed control

system (select with the rotary knob and confirm

with "OK"). The speed control system is available

for a solar cycle with asynchronous pump (con-

trolled by an A01.1 with "wave packets"), as well

as for one or two solar cycles with high-efficiency

pump (controlled by an A40.1 with "PWM").

We recommend activating an EC pump. The solar

pump adapts automatically to solar capacity. If the

temperature difference increases due to increased

solar capacity, the speed of the solar pump is

increased. (This results in a higher degree of effi-

ciency of the solar plant as well as lower power

consumption of the solar pump).

Fig. 80: Selecting the pump system

Menu item

Parameter

Factory setting

Pump type

(solar cycle)

Asynchronous

pump

EC pump

Selection

according to

pump type

installed in the

solar cycle

Solar speed control system

Activate if you want the solar pump to modulate

according to solar capacity

Activation of the speed control system for the

pump in the solar cycle: the pump can be activated

according to demand, for efficiency reasons; as

solar radiation increases, the speed of the pump

increases.

When using a pump which is not suitable for the

speed control system, the system should be deac-

tivated.

(We recommend use of a speed-controlled pump).

Fig. 81: Activating the speed control system

Menu item

Parameter

Factory setting

Solar speed

control

system

Deactivated

Deactivated

Activated

Menu item

Parameter

Factory setting

Asynchro-

nous speed

control

system

On

On

Off

45