REMKO WPM-Smart-Control-Manual for specialists-WKF-120 - Manual (Page 47)

Heat carrier medium
Select (select with the rotary knob and confirm with
"OK") the type of solar fluid used, in order to calcu-
late the amount of solar heat.
Fig. 84: Selecting the heat carrier medium
Menu item Parameter
Fac-
tory setting
Heat carrier
medium
Water
TYFOCOR-L
DOWCAL 10
DOWCAL 20
TYFCOR
TYFOCOR-L
TYFOCOR-LS
ANTIFROGEN-N
ANTIFROGEN-
SOL
Temper-10
Temper-15
Temper-20
Temper-30
Temper-40
Temper-55
GLYTHERMIN P44
Press "Next".
Set temperature of the storage tank during
solar charging
Once the solar set temperature is reached, the
solar cycle pump is switched off. With the collector
cooling function activated, the temperature of the
storage tank can continue to rise as far as the set
maximum temperature.
The solar set temperature (select with the rotary
knob and confirm with "OK") should be reduced if
the hot water temperature is regularly too high or if
there is no thermostatic mixing valve installed. At
the same time, when the collector cooling function
is activated, the max. temperature of the storage
tank must be reduced.
Fig. 85: Set temperature of the storage tank
Menu item Parameter Factory setting
Solar set
temperature
5°C - 95°C 85°C
Press "Next".
47