REMKO WPM-Smart-Control-Manual for specialists-WKF-120 - Manual (Page 62)

"Information" menu item (continued) - Expert
Authorisa-
tion level
Level 2 menu
item
Level 3 menu item Info
Heat pump
Heat pump status
You can find
many of the indi-
vidual info texts
about the level
2-3 menu items
on your Smart
Control
Remaining idle time
Defrost status
Compressor status
Fault code (outside)
Fault code (inside)
Target temperature A44
Enable signal A33
Disable compressor A30
Heat pump mode A31
Disable signal S16, energy supplier cut-off
Heat pump therm. output
Maximum frequency
Compressor frequency
Max. inlet temperature
Fan status
Fan speed, outdoor unit
Fan temperature, outdoor unit
Refrigerant temp. S07
Test mode, outdoor unit
4-way valve
Current consumption
Expansion valve position
Run-time (minutes)
Run-time (hours)
Heat pump therm.energy
Cont. HW offset
Cont. heating offset
Short-term HW offset
Short-term heating offset
REMKO Smart WP MANAGER
62