REMKO WPM-Smart-Control-Manual for specialists-WKF-120 - Manual (Page 33)

Hot water circulation
If there is a hot water circulation pump in the
building, which you are intending to operate in an
energy-saving manner using the controller, this
function must be activated (select with the rotary
knob and confirm with "OK").
Fig. 43: Hot water circulation
Menu item Parameter Factory setting
Hot
water
circulation
Deactivated
As required
Activated
Press "Next".
Circulation type
(dependent on which probes are used)
Impulse circulation:
If briefly dispensing water triggers an impulse on
the flow-operated safety device, this is registered
by the controller and the circulation pump is started
up. This means that the circulation is also active
when it is required.
Temperature-guided circulation:
Temperature-guided circulation keeps the hot
water temperature at the set temperature.
Select the circulation type with the rotary knob,
then confirm the entry with "OK".
Fig. 44: Selecting the circulation type
Menu item Parameter Factory setting
Circulation
type
Impulse
circulation
As required
Temperature-
guided circula-
tion
Press "Next".
33