2 commissioning wizard, Remko smart wp manager, Commissioning wizard – REMKO WPM-Smart-Control-Manual for specialists-WKF-120 User Manual
Page 28

4.2
Commissioning wizard
The commissioning wizard which starts when the
controller is activated is intended for programming
the controller for use on the existing system. When
the individual parameters are activated or deacti-
vated, corresponding parameter sets are uploaded
automatically, although they are not visible. After
commissioning has been fully completed, the
default set of parameters is enabled. During the
first heating period the thermal characteristics of
the system should be observed, and the parame-
ters optimised as necessary. The lower the
selected water temperatures, the more efficient
operation of the heat pump will be.
You can find simplified commissioning exam-
Ä Chapter 4.3 ‘Template hydraulic dia-
grams with installation parameters’
Should you require the installation wizard again at
a later point in time (e.g. if you are expanding the
existing system), then you can also call it up man-
ually at any time from the main menu.
Proceed with installation as follows:
Fig. 28: Setting parameters
Fig. 29: Confirm the entry with "OK", then jump to
the next setting with "Next"
Assigning the unique unit identifier
Here you can address up to 3 Smart Control units.
Select the unit identifier with the rotary knob and
confirm the entry with "OK". The unit ID number
appears before a red, flashing field in the top right
of the display.
1
Fig. 30: Assigning the unit identifier
Menu item
Parameter
Factory setting
Con-
trol panel 1
address
Control panel 1
Control panel 1
Control panel 2
Control panel 3
Press "Next".
REMKO Smart WP MANAGER
28