Measurement Computing Micro 488/EX rev.2.1 - Manual (Page 97)

Section 5 Command Descriptions
5.27
DISARM
The DISARM command prevents the Micro488/EX from sending the event's
status message to the serial host, even when the specified conditions occur. It is also
used to disable the ON DOMACRO response. The user's program can still
check for the events by using the STATUS 1 command.
If the DISARM command is invoked without specifying any events, then all
events will be disabled.
The ARM or ON DOMACRO commands may be used to re-enable the
event responses.
SYNTAX DISARM [;] [event[event…]]
or
DI
[;] [event[event…]]
event is one of SRQ, PERIPHERAL, CONTROLLER, TRIGGER,
CLEAR , TALK, LISTEN, IDLE, CHANGE, ERROR or STARTUP.
RESPONSE None
MODE Any
BUS STATES None
EXAMPLES PRINT#1,"DISARM" Disable all conditions
PRINT#1,"DISARM SRQ" Do not respond to SRQ