Measurement Computing Micro 488/EX rev.2.1 - Manual (Page 25)

Section 2 Getting Started
2.11
SW2 View for Mode Selection
OPEN
1 2 3 4 5 6 7 8 DOT
Switch
Side
View
System Controller
OPEN
1 2 3 4 5 6 7 8
Peripheral
OPEN
1 2 3 4 5 6 7 8
Controller Pass-Thru
OPEN
1 2 3 4 5 6 7 8
Peripheral Pass-Thru
2.6 IEEE Address Selection
SW3-1 through SW3-5 select the IEEE bus address of the Micro488/EX when in
the System Controller, Peripheral and Peripheral Pass-Thru modes. These same
switches are used in the Controller Pass-Thru mode to select the address of the device
that will be controlled. [Refer to Section 6 for additional information]. The address is
selected by simple binary weighting with SW3-1 being the least significant bit and
SW3-5 the most significant. The factory default is address 10.