Measurement Computing Micro 488/EX rev.2.1 - Manual (Page 3)

Table of Contents
Section 1 Introduction Page
1.1 Description 1.1
1.2 Available Accessories 1.2
1.3 Specifications 1.3
1.4 Abbreviations 1.4
Section 2 Getting Started Page
2.1 Inspection 2.1
2.2 Configuration 2.1
2.3 Serial Port Settings 2.3
2.3.1 Serial Baud Rate Selection 2.4
2.3.2 Serial Word Length Selection - Data Bits 2.5
2.3.3 Serial Stop Bit Selection 2.5
2.3.4 Serial Parity Selection 2.5
2.3.5 Serial Echo Selection 2.6
2.3.6 Serial Handshake Selection 2.7
2.4 Terminator Selection 2.8
2.4.1 Serial Terminator Selection 2.8
2.4.2 IEEE Bus Terminator Selection 2.9
2.5 Mode Selection 2.10
2.6 IEEE Address Selection 2.11
2.7 Feature Selections 2.12
2.7.1 Controller Pass-Thru Features 2.12
2.7.2 Peripheral Pass-Thru Features 2.13
2.8 Serial Interface 2.13
2.8.1 RS-232/RS-422 Signal Level Selection 2.13
2.8.2 Serial Signal Descriptions 2.14
2.8.3 Serial Cable Wiring Diagrams 2.16
2.9 General Operation 2.18
2.10 Is There Anyone Out There 2.20
Section 3 IEEE Operating Modes Page
3.1 Introduction 3.1
3.2 Operating Mode Transitions 3.1
3.3 System Controller 3.3
3.4 System Controller, Not Active Controller 3.4
3.5 Not System Controller 3.7