Measurement Computing Micro 488/EX rev.2.1 - Manual (Page 71)

Section 5 Command Descriptions
5.1
Command Descriptions
5.1 Introduction
This section contains a detailed description of each of the high-level commands
available for the Micro488/EX. There are two types of commands: bus commands and
system commands. Bus commands communicate with the IEEE 488 bus. System
commands configure or request information from the Micro488/EX.
Bus Commands:
ABORT PASS CONTROL REQUEST
CLEAR PPOLL RESUME
ENTER PPOLL CONFIG SEND
LOCAL PPOLL DISABLE SPOLL
LOCAL LOCKOUT PPOLL UNCONFIG TRIGGER
OUTPUT REMOTE
System Commands:
ARM ERROR SAVE
CASE FACTORY SET DATE
COMMENT HELLO SET DAY
COUNT ID SET TIME
DATE LOG STATUS
DATE FORMAT LOG MEMORY STERM
DAY MACRO…ENDM TERM
DAY FORMAT MASK TIME
DELAY MEMORY TIME FORMAT
DISARM ON DOMACRO TIME OUT
DOMACRO READ TRACE
ERASE READ LOG WAIT
ERASE LOG RESET