Measurement Computing Micro 488/EX rev.2.1 - Manual (Page 15)

Section 2 Getting Started
2.1
Getting Started
2.1 Inspection
The Micro488/EX was carefully inspected, both mechanically and electrically,
prior to shipment. When you receive the interface, carefully unpack all items from the
shipping carton and check for any obvious signs of physical damage which may have
occurred during shipment. Immediately report any such damage found to the shipping
agent. Remember to retain all shipping materials in the event that shipment back to the
factory becomes necessary.
Every Micro488/EX is shipped with the following....
• Micro488/EX IEEE 488 Bus Controller
• 127-0920 Instruction Manual
• Power Supply TR-2; 115V or
TR-2E; 220/230V
2.2 Configuration
Three DIP switches internal to the Micro488/EX set the configuration of the
interface. NOTE: Selectable functions are read ONLY at power-on and should only be
set prior to applying power to the interface. The following figures illustrate the factory
default conditions which are:
Serial Port: IEEE:
9600 Baud Mode = System Controller
8 Data Bits Address = 10
2 Stop Bits Bus Terminator = CR-LF; EOI Disabled
No Parity Talk-back Enabled
Serial Terminator = CR-LF
Echo Disabled
RTS/CTS Handshake