Measurement Computing Micro 488/EX rev.2.1 - Manual (Page 112)

Section 5 Command Descriptions
5.42
LOG MEMORY
The LOG MEMORY command is used to inquire the number of characters
contained within the LOG Buffer. After an ERASE LOG or FACTORY command, the
LOG
Buffer will contain zero [0] characters.
SYNTAX LOG MEMORY
RESPONSE Number of characters contained within the Log Buffer.
MODE Any
BUS STATES None
EXAMPLES PRINT#1,"MACRO 1" Define a macro
PRINT#1,"HELLO"
PRINT#1,"ENDM"
PRINT#1,"LOG ON"
Enable logging
PRINT#1,"DOMACRO 1" Execute the macro
The response is logged
PRINT#1,"LOG MEMORY"
INPUT #1,L
Read the memory used
PRINT L Printed to the screen
54 Number of bytes in buffer
PRINT#1,"ERASE LOG" Erase the log buffer
PRINT#1,"LOG MEMORY"
INPUT #1,L
Read the memory used
PRINT L Printed to the screen
0 0 bytes in buffer