Hypertherm HD3070 Plasma Arc Cutting System w/ Automatic Gas Console - Manual (Page 95)

00% 00% 00% 00% 00% 00%
INLET GAS REMOTE or LOCAL INLET GAS
PREFLOW SHIELD
XXX PSI/BAR XXX PSI/BAR XXX PSI/BAR
PLASMA
4-6 HD3070 with Automatic Gas Console Instruction Manual
16
OPERATION
Figure 4-3 Automatic Gas Console Front Panel LCD Display
Indicates local
or remote control
system operation Indicates plasma
inlet gas in
psi or bar
(120 psi/8.28 bar)
Indicates plasma
outlet gas pressure
Indicates location
of preflow gas
pressure and
flowrate fields Indicates shield inlet
gas in psi or bar
(120 psi/8.28 bar)
Indicates preflow
outlet gas pressure Indicates shield
outlet gas pressure
Indicates location
of shield gas
pressure and
flowrate fields Indicates location
of plasma gas
pressure and
flowrate fields
Indicates PS-ERR (power
supply system error). Refer
to Power Supply System
Error List. Indicates either system test, calibrate or purge modes:
TEST PREFLOW or TEST CUTFLOW; CAL ZERO or
CAL SPAN; or automatic PURGE PREFLOW or PURGE
CUTFLOW for 20 seconds each. Indicates GS-ERR (gas
system error). Refer to
Gas System Error List.
Indicates shield
cut flowrates Indicates preflow
flowrates Indicates plasma
cut flowrates
Potentiometer 6 and
associated LCD display
field only operate when
H35 is selected.
00% 00% 00% 00% 00% 00%
INLET GAS REMOTE or LOCAL INLET GAS
PS-ERR GS-ERR
XXX PSI/BAR XXX PSI/BAR XXX PSI/BAR
TEST, CALIBRATE or PURGE MODE