Guralp Systems CMG-CD24 User Manual
Page 19
Operator's Guide
standard Güralp Systems power/data cable to this port and use
Scream! to access the console.
3. Channel 2 (port 10002) is connected to the CD24's digital
output, unless you have connected a serial data cable from the
breakout box to a computer. If the breakout box is connected,
the CD24 will send data streams through that interface rather
than to the Wi-Port.
4. Click on Channel 2 – Serial Settings.
5. If the Baud Rate is incorrect, set it to the default of 19,200.
Note: If you change the digitiser's output baud rate in Scream!
or using the terminal, you must come back to this page and
change the Baud Rate setting here as well.
6. The remaining settings can be left at their default values. Click
OK to save your changes.
7. For full information on the Wi-Port's configuration options,
please refer to the Wi-Port documentation, which is available on
the Lantronix Web site,
8. When you have finished setting up the Wi-Port, apply the new
settings by clicking Apply Settings. The Wi-Port will re-boot
with the new settings in effect.
Note: If the Wi-Port is still using an automatically chosen
random IP (beginning with 169.254), the IP address will change
when you do this. You will need to go back to DeviceInstaller
to find out the new IP address.
March 2011
19