Guralp Systems CMG-CD24 - Manual (Page 106)

CMG-CD24
parentheses. If you do wish to use DHCP, enter 0 at each
prompt (an IP address of 0.0.0.0 is used to select DHCP
operation).
2. If the digitiser is to be connected to a routed network, enter the
address of the default gateway in the same manner.
3. At the netmask prompt, enter 0 if you are using normal
(classful) internet addressing. If you have a non-standard or
classless addressing scheme, enter the number of bits of the IP
address to be used for network identification. Note that this is
not the standard way of specifying netmasks; it is more akin to
the /n modifier used in CIDR address specification.
7.4.4 Configuration of the WiFi interface
If your system has WiFi capabilities, they can be configured using the
same menu system.
1. From the main menu, select '4' and then press the Enter key to
access the WiFi settings.
2. Configure your topology, keying 0 for Infrastructure or 1 for
Adhoc mode and then press enter.
3. Enter the desired network name (SSID). Systems are shipped
with a default SSID of LTRX_IBSS so that they can be found
and configured by DeviceInstaller but you can enter any
suitable value here.
106 Issue C