Guralp Systems CMG-CD24 - Manual (Page 105)

Operator's Guide
From the main menu:
1. Each channel is configured individually. To configure either,
enter either 1 (selecting Channel 1) or 2 (selecting Channel 2)
and then press the Enter key.
2. Set the Baud Rate to 19200. This is the default baud rate for the
CD24's digital output. If you change the baud rate in Scream! or
using the terminal, you must change the Baud Rate setting here
to match.
3. The remaining settings can be left at their default values, which
is done by pressing Enter at each prompt until you are returned
to the main menu.
4. When you have finished setting up the module, apply the new
settings by selecting option 9 Save and Exit. The module will
re-boot with the new settings in effect.
7.4.3 Configuring the Ethernet port
To configure the Ethernet port
1. If DHCP is not being used to assign IP addresses, enter the
required address manually. The IP address must be set to a
unique value in the network. Enter each octet and press Enter
to move to the next octet.. The current value is displayed in
March 2011 105