Gasboy 1000 Series FMS Startup Manual - Manual (Page 44)

03/07/03 11-1
Section 11
START-UP COMMANDS
Use the following commands to set up the system at the initial start-up. The Series 1000
Operation Manual describes these commands in more detail. If you have the Fuel Point option,
refer to Appendix D of the FleetKey Operation Manual for command changes. If you filled in the
checklist in Section 2 of this manual, you already have all the information you need to start up your
system. In the examples, bold represents the information that you enter, and this symbol
↵
represents the RETURN key.
1.
Press CTRL F or RETURN. The system displays: SIGN ON:
2. Type
GASBOY and press RETURN. (The word GASBOY is shown in the illustration for
example only. You will not see the word GASBOY as you are typing it.) The asterisk prompt
* appears indicating that you are in Command Mode and can begin entering commands to
configure your Series 1000 System.
UECPÂQP0ÂC7U8Qa ↵
*
3. Type
LS to change the initial password (GASBOY) to one of your choice (up to 10
characters).
Â
HUÂ
R7UUYQT@0ÂR7UUYQT@
↵ Â
Â