Gasboy 1000 Series FMS Startup Manual - Manual (Page 17)

GASBOY Series 1000
3-2 03/07/03
✍
3. COMMUNICATION
Data Terminal:
The make and model number of the data terminal connected to
the system. If a data terminal is not being used, indicate not
applicable (N/A).
External Modem:
The make and model number of the external modem that is
connected to the system. This can include Short Haul Modems
used for distances over 1500 feet. If no external modems are
used, indicate not applicable (N/A).
Modem Phone No:
The area code and phone number for the internal or external
phone modem connected to the system. If a modem is not used,
indicate not applicable (N/A).
Port 1:
The method of communication used for Port 1 (direct printout
port). Circle either RS-232 or RS-422. Indicate the baud rate.
Port 2:
The method of communication used for Port 2 (secondary port).
Circle either RS-232, RS-422, or internal modem (Int. Modem).
Internal modem should be circled when the internal modem is
connected to Port 2 via the ribbon cable directly above the Port 2
RS-232 and RS-422 connectors. Nothing should be connected
to the RS-232 or RS-422 ports when the ribbon cable is
connected. Indicate the baud rate.
Aux. Port 1:
If auxiliary port 1 is used with a tank monitor, indicate the method
of communication. Circle either RS-232 or RS-422. Auxiliary
port 2 is always RS-232. Indicate the baud rate.
✍
4. BREAKERS
Enter the breaker number for each of the items listed. When multiple breakers are used for
powering a device (e.g., a breaker for the dispenser and a breaker for the submersible pump), list
both breakers. All breakers pertaining to the system should be in the OFF position at this time.