Gasboy 1000 Series FMS Startup Manual - Manual (Page 16)

03/07/03 3-1
Section 3
BEGIN START-UP FORM
PARTS 1 THROUGH 4
This section covers Parts 1 through 4 of the Start-up form. Parts 5 through 12 are covered in
subsequent sections. A sample filled-out Start-up form appears at the end of this book.
✍
1. SITE IDENTIFICATION
Customer:
The name of the company that owns the system.
Location:
The address of the site where the system is located.
Contact:
The name of a responsible contact person at the site.
Customer Phone No.:
The phone number where the contact person can be reached.
Date:
Today’s date (date of the start-up).
Distributor:
The distributor involved with the sale and/or installation of the
system.
Distributor Phone No.:
The phone number where the distributor can be reached.
Start-up Person:
The name of the person performing the start-up.
Installer:
The firm that installed the system.
✍
2. PUMPS/DISPENSERS
Fuel Type:
The type of fuel dispensed by that pump or dispenser (e.g., No-
Lead, Regular, etc.).
Fuel Code:
The product code number assigned to that fuel type.
Pump Make:
The name of the manufacturer of the pump or dispenser.
Pump Model #:
The model number of the pump or dispenser.
Pump Serial #:
The serial number of the pump or dispenser.
Motor Size:
The size of the motor used (e.g., 3/4HP, 1 1/2HP).
Pump Type:
The type of pump used to dispense the fuel. Is it a submersible
pump (Sub) located in the tank or is it a suction pump (Suc)
located in the pump housing? Circle one.
Starter Relay:
Is an external starter relay used to supply power to the pump.
Circle Y for yes or N for no.
Pulser Rate:
The pulser rate of the pulser used by that pump or dispenser
(e.g., $, 10:1, 100:1).