Gasboy 1000 Series FMS Startup Manual - Manual (Page 30)

Jumper and Switch Settings
03/07/03 5-11
6. Press F5 or PAGE DOWN to display the next Setup Screen, ANSI Setup.
7PUEÂUsˆ‰„Â
Â
Â
BGs“ÂHƒqy Qtt Us‚r 7€€Â
 Bsiˆ‰†sÂHƒqy Qtt R†w‚ˆÂ Piˆwƒ‚i€Â
 Gs“„ir P‰s†wq Us‚rÂ7†si Uq†ss‚Â
 9‰†‡ƒ†ÂGs“‡Â Pƒ†i€Â R†w‚ˆÂ7†si Uq†ss‚Â
 `ts†ÂVs†Â AQU Us‚rÂVs†Â Pƒ‚sÂ
 9vi†ÂIƒrs I‰€ˆw‚iˆwƒ‚i€Â R†w‚ˆÂVs†Â Pƒ‚sÂ
 9vi†ÂUsˆÂ @A9I9U R†w‚ˆÂIƒrs 7‰ˆƒÂ
 Gs“‡Â V“„s‘†wˆs†Â 7‰ˆƒÂ7‚‡‘s†piqy QttÂ
 XV! ÂE@ XVÂ!  Â
Â
7. Press
S to save Setup changes.
8.
Press F9 or E to exit Setup Mode.
OKIDATA 184 SETUP
To prepare the Okidata printer for operation with the LINK MC5 terminal and your GASBOY Fuel
Management System, perform the following steps. Install and complete the setup of the printer as
specified in the manufacturer’s setup instructions. Then set up the switches as follows:
SW1-1 ON
Parity: Odd
SW1-2 ON Parity: Without
SW1-3 ON Data bits: 8
SW1-4 OFF Protocol: XON/XOFF (Series 1000 V8.1 or higher)
ON Ready/Busy (Series 1000 versions prior to V8.1)
SW1-5 ON Test select: Circuit
SW1-6 ON Mode select: Print
SW1-7 ON Busy line selection: DTR - Pin 20
SW1-8 ON Busy line selection: DTR - Pin 20
SW2-1 OFF
Baud rate: 9600
SW2-2 ON Baud rate: 9600
SW2-3 ON Baud rate: 9600
SW2-4 ON DSR output signal: Active
SW2-5 ON Buffer threshold: 32 bytes
SW2-6 OFF Busy signal timing: 1 sec (min.)
SW2-7 ON DTR signal: Space after power on
SW2-8 OFF Not used
1.
Turn the printer offline by pressing SELECT. The SELECT light should go off.
2.
Position the print head at the top of the paper and press the TOF SET button.
3.
Put the printer back online by pressing SELECT. The SELECT light should go on.
4.
Press the MODE button until the light next to HSD is lit.
5.
Press the PITCH button until the light next to 17 is lit.
NOTE: Pitch may be set to a lower number (resulting in larger print) if transactions are less
than 80 characters.