Dynex DX-G1113 - Manual (Page 77)

Installing your car stereo 77
Installing the mounting brackets
To install the mounting brackets:
• If you are installing the brackets on the top or bottom of the housing (1), secure the
mounting brackets to the housing with Carriage bolts and Keps nuts or with studs and
nuts.
Or, if you are installing the brackets on the sides of the housing (2), secure the
mounting brackets (through the center holes) to the housing with two Carriage bolts
and Keps nuts or with studs and nuts.
Installing the new head unit
To install the new head unit:
• For two-shaft head units (1), slide the new head unit into the kit, then secure it with
shaft nuts.
Or, for DIN-head units (2), cut and remove the shaft supports, slide the DIN cage into
the radio housing, then secure the cage by bending the metal locking tabs down. Slide
the new head unit into the cage until it is secure.
1
2
1
2
DX-G1113.fm Page 77 Wednesday, August 16, 2006 3:38 PM