Dynex DX-G1113 - Manual (Page 59)

Installing your car stereo 59
Oldsmobile
Omega 1983-1984
To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the hex-head washer screws from the steering column trim panel, then pull
down on the rear edge of the panel, then remove it.
3 Remove the four Phillips screws from the top edge of the dash trim bezel.
4 Remove the two hex-head washer screws from the bottom of the dash trim bezel,
then remove it.
5 Cut and remove all mounting tabs on bracket 2 except the C tabs. Each mounting tab
has a letter stamped on the back of the tab. Cut the tabs with the blade pointed away
from you and your fingers.
6 Go to “Completing the installation” on page 76.
C
C
C
C
DX-G1113.fm Page 59 Wednesday, August 16, 2006 3:38 PM