Dynex DX-G1113 - Manual (Page 50)

50 Installing your car stereo
Chevrolet
S10 Pickup 1982-1985
S10 Blazer 1982-1985
GMC
S15 Pickup 1982-1985
S15 Jimmy 1982-1985
To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the four star-drive screws from the corners of the dash trim bezel.
3 Remove the one star-drive screw from the lower-right corner of the instrument cluster
panel, then remove the dash trim bezel.
4 Cut and remove all mounting tabs on bracket 5 except the B tabs. Each mounting tab
has a letter stamped on the back of the tab. Cut the tabs with the blade pointed away
from you and your fingers.
5 Go to “Completing the installation” on page 76.
B
B
DX-G1113.fm Page 50 Wednesday, August 16, 2006 3:38 PM