Dynex DX-G1113 - Manual (Page 28)

28 Installing your car stereo
Chevrolet
Blazer 1998-2001
S10 Pickup 1998-2001
GMC
Jimmy1998-2001
Sonoma 1998-2001
To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the two 9/32-inch hex-head screws from the knee bolster.
3 Pull down on the bolster, then remove the exposed hex-head screws on the base of the
dash trim bezel.
4 Remove one Phillips screw above the instrument cluster.
5 Unclip the dash trim bezel, then remove it.
6 Remove the two 9/32-inch screws that secure the factory head unit, then disconnect
the wiring.
7 Locate bracket set 10.
8 Go to “Completing the installation” on page 76.
DX-G1113.fm Page 28 Wednesday, August 16, 2006 3:38 PM