Dynex DX-G1113 - Manual (Page 43)

Installing your car stereo 43
Chevrolet
Lumina 1990-1994
To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the two screws from the lower steering column panel.
3 Pull the panel down to access the bottom portion of the radio trim bezel.
4 Pull the top and bottom edges of the bezel, then remove it.
5 Cut and remove all mounting tabs on bracket 5 except the A tabs. Each mounting tab
has a letter stamped on the back of the tab. Cut the tabs with the blade pointed away
from you and your fingers.
6 Go to “Completing the installation” on page 76.
A
A
DX-G1113.fm Page 43 Wednesday, August 16, 2006 3:38 PM