Dynex DX-G1113 - Manual (Page 44)

44 Installing your car stereo
Chevrolet
Lumina 1995-2000
Monte Carlo 1995-2000
To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Unclip the dash trim bezel, then remove it. (You may need to loosen the knee bolster).
3 Remove the two 7 mm hex-head screws that secures the factory head unit, then
disconnect the wiring.
4 Locate bracket set 10.
5 Go to “Completing the installation” on page 76.
DX-G1113.fm Page 44 Wednesday, August 16, 2006 3:38 PM