Cascading autodial numbers, Valid autodial numbers, Type a advanced settings – GAI-Tronics TMA Version 7.5.0 Telephone Management Application (TMA) User Guide (Ver. 7.5.0 and newer) User Manual
Page 42
Pub. 42004-479B
Telephone Management Application (TMA) User Guide
Page 39 of 128
e:\standard ioms - current release\42004 instr. manuals\42004-479b.doc
03/14
Cascading Autodial Numbers
If an attempt to call the primary number is unsuccessful, the telephone will release that call, and initiate
another call using the second autodial number in that memory bank. If the second call attempt also fails,
the telephone will attempt a third call to the third number stored in that memory bank.
Valid Autodial Numbers
Each memory location will accept up to 24 alphanumeric digits. The valid alphanumeric digits are 0–9,
A
, B, C, D,
P
(for DTMF #), H for a pause in the dialing sequence, and
for the DTMF star (see note).
N
OTE
:
Any digits other than 0–9 counts for two character digits of the 24-digit maximum.
Type A Advanced Settings
The Type A Advanced Settings Properties Form is shown below followed by an explanation of each
entry.