GAI-Tronics TMA Version 7.5.0 Telephone Management Application (TMA) User Guide (Ver. 7.5.0 and newer) - Manual (Page 31)

Pub. 42004-479B
Telephone Management Application (TMA) User Guide Page 28 of 128
e:\standard ioms - current release\42004 instr. manuals\42004-479b.doc
03/14
Table 5. General Property Parameters and Their Functions
Parameter Function
** Description Description is name entered (or assigned) to the telephone in the phone tree list
that will appear on TMA screens and reports.
Tag ID Tag ID is the site identification label for the telephone. The field is limited to 24
alphanumeric characters and should be unique and easily recognized. This ID
appears on TMA reports, but is not stored in the telephone memory.
** Type Type specifies the type of telephone installed and determines the telephone
settings. This property is set by the profile selected in the Phone Wizard and is
stored only in the TMA database.
Serial Number A Serial Number is programmed into every telephone during manufacture and is
read by TMA. This field is an important identifier during polling, and cannot be
changed.
Version Version identifies the firmware installed in the telephone at the time of
manufacture and cannot be changed.
** Date Created Date Created line identifies when the phone record was added to the TMA
database and cannot be changed.
Line Number Line Number is the PABX extension assigned to telephone, which TMA will dial
to send and receive data. The number must be entered exactly as it will be dialed
by the PABX, including any prefixes or area codes.
ANI Enabled* When checked, the telephone will transmit the ANI code using DTMF when the
called party requests it at the beginning of a call. The called party requests the
ANI transmission by keying the digits 00 (factory default setting), or if
configured, by the digit * or the digit #. Refer to “Voice Annunciation
Activation” on the Properties Form.
ANI* ANI is a four-digit code that serves as a unit ID when the telephone is set up to
provide unit location transmission on a voice call. Use of ANI is optional. Refer
to “Voice Annunciation Activation” on the Properties Form.
*N OTE : A DTMF receiver/decoder is required to process the received DTMF ANI code.