GAI-Tronics TMA Version 7.5.0 Telephone Management Application (TMA) User Guide (Ver. 7.5.0 and newer) - Manual (Page 20)

Pub. 42004-479B
Telephone Management Application (TMA) User Guide Page 17 of 128
e:\standard ioms - current release\42004 instr. manuals\42004-479b.doc
03/14
Step Explanation of Step Actions Installer Actions
10 A few seconds after the success tone of the previous step,
the telephone initiates a Call-In to the TMA PC.
The duration is typically 1 to 2 minutes, but could be up to
5 minutes. Approximately 1 minute after the Call-In
begins, two short tone bursts are output from the speaker (if
it is a hands-free model). Wait 1-2 minutes.
[ two tones]
Wait 2 minutes.
11 Within 40 seconds after the Call-In completion, the TMA
PC initiates a poll call to the Type A telephone. In this poll
call, TMA updates the telephone’s settings based on the
parameters contained in the original template phone.
N
OTE : During the poll call of a hands-free phone, two
short tone bursts are output from the speaker approximately
5 minutes into the poll call.
Wait 6 minutes.
[ two tones]
12 Wait 30 seconds after hearing these two short tone bursts
for the poll call to complete. Wait 30 sec
13 Return the
EMERGENCY
push-button switch harness plug
to the
EMERGENCY
connector J7 (if it was moved in Step
2). Make several test calls from the telephone to confirm
proper operation.
Reconnect the EMERGENCY
button. Test the telephone.
At the TMA PC Location
At the TMA PC, use the line number /location list to rename each new phone record as appropriate. (The
new phone records created are located in the “New Phones” group; the description was set as the creation
date and time and the PABX extension number.)
Make note of any unused or redundant phone records for later deletion.