Fluke Biomedical SigmaPace 1000 - Manual (Page 53)

Setup, Operation, and Maintenance
Service and Calibration
2
2-9
W Caution
To avoid damage to the Analyzer or adverse affects on its
performance, d o not expose the system to temperature
extremes. Ambient temperatures should remain between
18 and 40 °C. System performance may be adversely
affected if temperatures fluctuate above or below this
range.
Cleaning
Clean the exterior of the Analyzer occasionally with a cloth dampened with a
mild detergent solution. Take care to keep liquids out of the interior of the
unit.
W Caution
To avoid damage to the Analyzer or adverse affects on its
performance, clean it only by gently wiping down with a
clean, lint-free cloth dampened with a mild detergent
solution. Do not immerse the unit.
Carefully wipe down the cables and inspect them for damage and deterioration
of the insulation. Check the cable connections for integrity of the cable clamp
and strain relief.
Service and Calibration
If your new Analyzer fails to operate successfully, please contact the Fluke
Biomedical Service Center immediately, as indicated under “Warranty and
Product Support.”
W Caution
To avoid damage to the Analyzer or adverse affects on its
performance, a llow only qualified technical personnel to
service the Analyzer.
Calibration of the Analyzer by an authorized Fluke Biomedical Service Center
is recommended. Fluke Biomedical Service Centers have the appropriate tools
and procedures for performing calibrations as well as factory-authorized
updates.