Transcutaneous pacemaker remote setup and testing – Fluke Biomedical SigmaPace 1000 User Manual
Page 136
SigmaPace 1000
Operators Manual
5-6
ERR=03
Illegal parameter. A parameter sent as part of the command was not the
correct type or was out of range; or, it contained an incorrect number of
parameters.
Transcutaneous Pacemaker Remote Setup and
Testing
The following commands are associated with setting up and testing a
transcutaneous pacemaker in remote mode.
SETMODE
SETMODE=TQPACE
Selects the Analyzer’s transcutaneous pacer test mode of operation.
Note
All subsequent serial port communications must relate to
transcutaneous pacer features and follow the prescribed
measurement protocols listed below.
See also other documents in the category Fluke Biomedical Equipment:
- 7000DP Impulse Supplement (12 pages)
- 7000DP Impulse Getting Started (36 pages)
- 7000DP Impulse (92 pages)
- 06-526-2200 (26 pages)
- 07-417 (16 pages)
- 07-443 (14 pages)
- 07-451 (8 pages)
- 07-487 (12 pages)
- 07-453 (24 pages)
- 07-555 (8 pages)
- 07-553 (10 pages)
- 07-605-7777 (8 pages)
- 07-444 (46 pages)
- 07-618 (10 pages)
- 07-600 (6 pages)
- 07-591 (8 pages)
- 07-653 (8 pages)
- 07-633 (20 pages)
- 07-649 (14 pages)
- 07-661-7662 (12 pages)
- 07-645 (14 pages)
- 10100AT (80 pages)
- 07-644 (10 pages)
- 18-203 (4 pages)
- 07-621 (12 pages)
- 07-647 (12 pages)
- 18-207 (8 pages)
- 18-216-1000 (10 pages)
- 18-220 (10 pages)
- 18-228 (8 pages)
- 18-223 (18 pages)
- 18-229-1313 (6 pages)
- 18-250 (8 pages)
- 18-252 (6 pages)
- 18-303 (6 pages)
- 35035 (19 pages)
- 6000-528 (18 pages)
- 35080B (70 pages)
- 6000-529 (16 pages)
- 35080M (64 pages)
- 6000-530B (16 pages)
- 57-436 (12 pages)
- 57-440 (12 pages)
- 57-402 (32 pages)