Comtech EF Data CLO-10 - Manual (Page 63)

CLO-10 Link Optimizer Revision 1
Front Panel Operation MN/CLO-10.IOM
6.4 CONFIG (Configuration)
CONFIG: Remote BW Uplink
Downlink Remod CnC Misc
Move the cursor to the desired choice using the ◄ ► arrow keys, then press ENTER .
The submenus available under the Configuration menu branch are as follows:
Selection
(Chapter Sect.)
Submenu Description
Remote
(6.4.1)
Permits the user to define whether the unit is being controlled locally
or remotely.
NOTE: The unit may be monitored over the remote control bus at any
time. When in Local mode, however, configuration parameters may only
be changed through the front panel. Conversely, when in Remote
mode, the unit may be monitored from the front panel, but configuration
parameters may only be changed via the remote control bus.
BW
( 6.4.2)
Permits the user to define the bandwidth parameter for the link
optimizer.
Uplink
(6.4.3)
Permits the user to define, on a parameter-by-parameter basis, the
uplink configuration of the unit.
Downlink
( 6.4.4)
Permits the user to define, on a parameter-by-parameter basis, the
downlink configuration of the unit.
Remod
( 6.4.5)
Permits the user to define, on a parameter-by-parameter basis, the
remodulator (CLO-10 output to the demod) configuration of the unit.
CnC
(6.4.6)
Permits the user to define the minimum and maximum search delays,
and the frequency offset parameters.
Misc
(6.4.7)
Permits the user to set alarm masks, choose between the 10MHZ
internal reference or phase lock to an externally applied reference,
and enable/disable redundant operations for units equipped for this
optional functionality (refer to
Appendix A. REDUNDANCY SYSTEM
OPERATION for detailed information on this option).
6–7