Comtech EF Data CLO-10 - Manual (Page 76)

CLO-10 Link Optimizer Revision 1
Front Panel Operation MN/CLO-10.IOM
6.7 INFO (Information)
INFO: Remote Bw Uplink
Downlink Remod CnC Ref
These screens display information on the current configuration of the unit. Select Remote, Bw,
Uplink, Downlink, Remod, CnC or Ref using the ◄ ► arrow keys, then press
ENTER .
INFO: Remote (Remote Control Information)
Select INFO: Remote to show if the unit is in Local or Remote mode; the display gives details
of the selected electrical interface type, the unit’s address, the selected baud rate, etc., as per the
following examples:
Remote M&C: Monitor Only
(Local Control only)
Remote M&C: RS485-4Wire
Address: 0001 19200 Baud
Remote M&C: 100BaseTx
IP Addr: 255.255.255.255
Press ENTER or CLEAR to return back to the previous menu.
INFO: Bw (Bandwidth Information)
Select INFO: Bw to display the unit’s Bandwidth:
Bandwidth:
256 kHz (ENT)
Press
ENTER or CLEAR to return back to the previous menu.
INFO: Uplink (Uplink Information)
Select INFO: Uplink to display the unit’s Uplink Frequency:
Uplink:
0070.0000 MHz (ENT)
Press ENTER or CLEAR to return back to the previous menu.
6–20