Comtech EF Data CLO-10 - Manual (Page 45)

CLO-10 Link Optimizer Revision 1
Rear Panel Connectors MN/CLO-10.IOM
3.5 M&C 10/100 BaseT Ethernet Management Port (RJ-45)
This is a standard RJ-45 female connector used for management via Telnet, HTTP (future), and
SNMP (future). It is also used for upgrading CLO-10 firmware. This receptacle uses a UTP
cable to connect to an Ethernet hub, router, switch, PC, etc.
Table 3-4. M&C Interface Connector Pin Assignments
Pin # Description Direction
1 Tx+ Out
2 TX- Out
3 Rx+ In
4 N/A
5 N/A
6 Rx- In
3–3