Comtech EF Data CDD-562L - Manual (Page 241)

CDD-562L/564 Demodulator with IP Module Revision 2
Appendix D MN/CDD564L.IOM
D–25
D.4.1.6 Redundancy Query
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Redundancy State N/A 1 byte, value of
0 or 1 Query only.
Returns the redundancy state of the unit, where
0 = Offline
1 = Online
Example: RED=1 (which is Online) N/A RED? RED=x
(see Description of Arguments)
D.4.1.7 Routing Commands and Queries
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Route Table Get N/A N/A Query only.
Gets the whole Routing Table of the modem.
Each route entry is separated by ‘\r’ [chr(13)]
Notes:
The route table will be displayed only if system’s working mode is “Router –Small, Router-
Large, Router-PtP.
If the system is in EasyConnect mode, it may return RCG!
RCG! RCG? RCG=
xxxxxxxxxxxxxx
xxxxxxxxxxxxxx
Delete route entry RTD= RTD=4 bytes,
numerical Command Only.
Deletes the route entry at the specified index number, if configured.
Note: Returns RTD! if there is no route at the index.
RTD =
RTD! RTD=xx.xx
(see Description of Arguments)
Number of route
entries N/A RTN=3 bytes,
numerical
Query Only.
Returns the number of route entries in the route table.
Note: This command should be issued whenever a new route is added/deleted. RTN =
RTN!
RTN? RTN=xxxx
(see Description of Arguments)