Comtech EF Data CDD-562L - Manual (Page 102)

CDD-562L/564 Demodulator with IP Module Revision 2
Quick Start Guide MN/CDD564L.IOM
7–10
2 Enter ‘1’ to configure the first route.
3 Enter a suitable name (e.g., ‘test’)
4 Set IP Address to ‘172.16.10.0’
5 Set Number of Subnet Bits to ‘24’.
6
For Interface to which route is destined to
select ‘S’.
7
For HDLC address [SMALL NETWORK] in hex <0x1 - 0xFE, enter = 0000>:
select ‘1’.
8 Per this example, the CDM-IP 2 Route Table should now display the following:
Route Name Dest IP/SNet Bits Next Hop MultiCast State
Route001...[test 172.16.10.0/24 0x1 N/A toSat]..1
9 Go to “Per Route” by pressing [E], then disable ‘HdrCompression’, ‘PayloadCompression’ and
‘3xDES’ by selecting ‘No’ (‘Clear’ for 3xDES) for each of these choices.
Finally, perform the following steps on the Satellite IP Demodulator (CDD-56X) 3:
Step Task
1 From the CLI Main Menu, select the Route Table [R] submenu.
2 Enter ‘1’ to configure the first route.
3 Enter a suitable name (e.g., ‘ToCDMIP2’).
4 Set IP Address to ‘172.17.10.0’.
5 Set Number of Subnet Bits to ‘24’.
6
For Interface to which route is destined to
select ‘E’.
7 Set the Next-hop IP Address to ‘172.16.10.1’.
8 Per this example, the CDD-56X Demod 3 Route Table should now display the following:
Route Name Dest IP/SNet Bits Next Hop MultiCast State
Route001...[ToCDMIP2 172.17.10.0/24 172.16.10.1 N/A toEth]..1
9 If the Header Compression Feature is available on this demodulator, do the following:
From the CLI Main Menu, select Administration [A] Æ Features Configuration [F] Æ
RxHeaderCompression [H], then press ‘1’ to disable the Header Compression on ‘Demod 1’.
At this point the basic configuration is over and the user should be able to:
ƒ Ping PC 1 from PC 2 and vice versa;