Comtech EF Data CDD-562L - Manual (Page 121)

CDD-562L/564 Demodulator with IP Module Revision 2
CDD-56X CLI and Telnet Operation MN/CDD564L.IOM
8–17
8.2.3.1 Ethernet Interface page
Access the Ethernet Interface page from the Interface Configuration page.
This page contains the following unique selections/fields:
Selection Entry Description
MAC Address [RO] The MAC Address defines the hardware destination MAC Address
that is used when an Ethernet packet is destined for the demodulator
Traffic Ethernet Interface. This address is unique and has been
assigned permanently at the factory.
Speed/Mode E The Ethernet Speed Mode is a configurable parameter and thus its
exact setting can vary between specific installations. The default
setting allows the Ethernet port to auto negotiate its link speed on
power-up.
Selections are:
1 -- Auto
2 -- 10 MB/sec Half Duplex
3 -- 100 MB/sec Half Duplex
4 -- 10 MB/sec Full Duplex
5 -- 100 MB/sec Full Duplex
IP Address I This is the IP Address assigned to the Ethernet Traffic Interface.
Enter the IP address in aaa.bbb.ccc.ddd format
Subnet Prefix Length M Specifies the Subnet Mask assigned to the Ethernet Traffic Interface.
Enter the subnet mask prefix length (valid range is from 8 to 30).
Link Status [RO] Displays the Ethernet Link status like the speed, duplex, and whether
the link is ‘UP’ Or ‘DOWN’.
Managed Switch Gateway IP G Selectable only when Managed Switch is the selected Working
Mode: This is the IP Address assigned to the Managed Switch
Gateway. Enter the IP address in aaa.bbb.ccc.ddd format