Compuprint 10200 Programmer Manual - Manual (Page 83)

Commands
79
255 Initializes printer to default settings. The download font is initialized. If parameters
are specified, they overwrite the default settings. This command will change data
stored in the macro’s non-volatile RAM. It will copy default settings from ROM, add
parameter changes, if any, and store in working RAM and all macros. It will also set
the default macro to disable.
id The id parameter specifies the printer for which the following parameter bytes are
intended. If the ID does not address your printer, the mode bytes that follow are
ignored. The ID values are Hex = B6, Dec = 182.
parm
1
Specifies the following functions:
Bit Not set Set
7 Discard byte Process this byte Ignore this byte
6 Reserved
5 Alarm Alarm enabled Alarm disabled
4 Automatic CR No CR on vertical movement CR on vertical movement
3 Automatic LF No LF after CR LF after CR
2 Page length 11 inches 12 inches
1 Slashed zero Zero without slash Zero with slash
0 Character set CS1 CS2