Compuprint 10200 Programmer Manual - Manual (Page 81)

Commands
77
ESC @
Initializes the printer. (EPSON)
ASCII Code ESC @
Hexadecimal Value 1B 40
Decimal Value 27 64
This sequence causes the printer:
•
to go back to the current printer setup settings
•
to cancel any selected print attributes
•
to reset the column counter
•
to set the horizontal tabulations every 8 columns
•
to clear all vertical tabulations
Only the selection of Draft/Quality printing, DLL and the selected character generator are
maintained.
ESC [ K
Sets initial conditions. (IBM 2391 + only)
ASCII Code ESC [ K n
1
n
2
init id
Hexadecimal Value 1B 5B 4B n
1
n
2
init id
Decimal Value 27 91 75 n
1
n
2
init id
This command causes the printer to reset to its initial status:
n
1
,n
2
The n
1
and n
2
parameters specify the number of bytes in the escape sequence normally,
n
1
= 2 and n
2
= always 0.
init The init parameter specifies to which condition the printer should initialize, normally
init = 0,1,4,5,254,255.