Compuprint 10200 Programmer Manual - Manual (Page 48)

Commands
44
ESC M
Selects 10.5 point. 12 CPI. (EPSON)
ASCII Code ESC M
Hexadecimal Value 1B 4D
Decimal Value 27 77
This is a terminator code. It causes all data present in the print buffer to be printed. Subsequent
data will be printed at 12 cpi if you previously set the compressed spacing by sending the SI or
ESC SI command. If you select the proportional printing, this command is stored.
ESC m
Selects magenta ribbon band. (IBM)
ASCII Code ESC m
Hexadecimal Value 1B 6D
Decimal Value 27 109
This command selects the magenta ribbon band.
ESC P
Selects 10.5 point, 10 cpi. (EPSON)
ASCII Code ESC P n
Hexadecimal Value 1B 50 n
Decimal Value 27 80 n
This command selects 10.5-point, 10-cpi character printing. If you change the pitch during
proportional mode (selected with the ESC p command) the change takes effect when the printer
exits proportional mode.