Compuprint 10200 Programmer Manual - Manual (Page 21)

Commands
17
ESC B NUL
Resets vertical tab stops.
ASCII Code ESC B NUL
Hexadecimal Value 1B 42 00
Decimal Value 27 66 00
Resets vertical tab stops in the 0 Vertical Format Unit (VFU) channel.
ESC b
Sets vertical tab stops in one of the 8 Vertical Format Unit channels available. (EPSON)
ASCII Code ESC b m n
1
... n
x
0
Hexadecimal Value 1B 62 m n
1
... n
x
00
Decimal Value 27 98 m n
1
... n
x
0
Range 0 < m < 7
1 < n
1
... n
x
< 255
This sequence sets vertical tabulations in the VFU channel specified by the parameter m.
The VFU channel can be imagined as a blank page where you can set up to 16 vertical
tabulations in order to format your page as you like. 8 channels are available and in each of
them you can create a sample page that you can recall later. n
1
to n
16
specify the lines at which
vertical tabulations must be set.
The values of n must be in ascending order. If you change the vertical spacing, the vertical
tabulations set are not cancelled and they maintain their physical position on the page.
The vertical tabulations set in the channel specified by the m parameter are executed by the VT
code when the
specific channel is selected by the ESC / command, this code is executed as a line
feed.